Nulon 2 Stroke Full Synthetic Bike & Kart Engine Oil is an advanced, practically ashless/low ash formulation designed to provide optimum wear protection and low smoke production. Developed with biodegradable ester base oils, it is ideally suited for use in two-stroke engines found in motorcycles, go-karts, scooters and mopeds that use either a premix or oil injection system. Suitable for use in a wide range of recreational, motorcycle and go-kart applications where ester-based products are recommended.

Nulon 2 Stroke Full Synthetic Bike & Kart Engine Oil exceeds API TC, ISO EG-D and JASO FD specifications and should be used as per the below ratios. Check your owners handbook for the required mix ratio for your engine.

Features:

• Low smoke
• Dyed so that your fuel changes colour when you mix it
• Reduces exhaust port blockages
• Low deposits to keep piston rings free
• Enhanced lubricity
• Biodegradable
• Mixes readily with petrol

Directions for Use:

Simply add Nulon 2 Stroke Full Synthetic Bike & Kart Engine Oil to your fuel tank at the recommended treatment rate shown below.

Treatment Rate:

Treatment Rate:

• 25:1 ratio – Add 200 mL of oil to 5 litres of petrol
• 50:1 ratio – Add 100 mL of oil to 5 litres of petrol
• 100:1 ratio – Add 50 mL of oil to 5 litres of petrol

How to Use Measuring Chamber

1. Loosen the cap on the measuring chamber slightly (about half a turn) to allow air to escape.
2. Squeeze the bottom of the bottle to push oil into the chamber until the desired dose is reached.
3. Release the bottle and remove the cap from the measuring chamber.
4. Pour the measured oil into your fuel container.
5. Ensure the oil is thoroughly mixed with petrol before adding the mixture to your fuel tank.
6. If your system uses oil injection, add the required amount directly to the oil tank.
7. Replace the cap and tighten it for storage.

Note:

• Always refer to your motorcycle or equipment service manual for correct lubrication requirements and service intervals.

Industry Specifications:

• American Petroleum Institute (API): SL
• American Petroleum Institute (API): TC
• Japanese Engine Oil Standards (JASO): JASO FD
• ISO: EG-D

First Aid and Safety:

WARNING: Combustible liquid.

Safety

• Avoid skin contact with used product.
• If skin contact occurs, wash area thoroughly with soap and water.
• For advice, contact a Poisons Information Centre:
  • Australia: 13 11 26
  • New Zealand: 0800 764 766
• Or contact a doctor immediately.

Environment

• Do not pollute drains, soil, or water with used products.
• After use, dispose of container in a responsible manner.
• Do not dispose of to landfill.
• Disposal of container should comply with local council regulations.

Part number: FS2ST-1