Features

• Will not sag, run or drip
• Easy to use - no mess
• Can be drilled, sawed, sanded, filed, tapped, machined or painted one hour after mixing
• Good adhesive strength
• Can be used to reshape, rebuild and repair a multitude of surfaces and applications
• Good gap filling properties
• Long-lasting, durable solution
• Heat resistant to 120°C continuously or 140°C intermittently
• Rapid Set (<10 minutes)

Where can this product be used?

• Metal petrol tank repairs
• Radiator and oil pan repairs
• Leaking gaskets repair
• Filling in scratches, small dents, gouges and holes in panels
• Bonding of trim
• Filling rust holes
• Thread locking
• Anchoring bolts and screws
• Repairing other metal and plastic parts and
  pipes

What materials is this product suitable for?

• Metals
• Wood
• China
• Some rigid plastics*
• *Does not adhere to polyethylene, polypropylene or Polytetrafluoroethylene (Teflon) or silicone rubber

How to Use

1. Clean surface free of grease, dirt and dust. For best results roughen bond area prior to cleaning.
2. Wear protective gloves. Cut off required amount. Replace disc on remaining portion. To mix, knead with fingers to a uniform colour.  If mixing is difficult, warm to room temperature.
3. Apply to surface to be repaired (within 2 minutes of mixing) and mould to shape if required.
4. For a smooth appearance, remove excess and hand rub with water or a damp cloth before hardening begins.
5. Trim away any excess before initial hardening. Remove any residues with acetone prior to initial hardening. Hardened excess may be sanded or trimmed away once fully cured.
6. After 5-10 minutes Selleys Auto Fix Knead-It will harden and begin to form a strong bond. After 60 minutes it may be drilled, sanded, machined, filed, sawed or painted.
7. Wash hands thoroughly with soap and water before product hardens.

Limitations:

• Not recommended for filling or sealing joints/cracks subject to movement as the cured product is extremely hard and inflexible
• *Does not adhere to polyethylene, polypropylene or Polytetrafluoroethylene (Teflon) or silicone rubber

Handy Tips

• Ensure the putty and hardener are mixed properly. Knead-It will become warm as it is mixed. A good indication its mixed properly is when you have a uniform colour, and feel a mild heat radiating from the Knead-It.
• To help determine when your knead it has set, keep a small piece off to check- when it is hard, it indicates your job is done.
• Set time increases at temperatures below 20°C.
• A few drops of water can help make kneading the putty easier.
• Use Knead-It Aqua for applications in wet/ submerged areas.
• Use Knead-It Steel for applications on metal or fuel contact.

Clean Up

• Residue may be removed with acetone.
• Cured product can be softened with heat to make scraping easier.