Nulon Green General Purpose Coolant Premix is a ready to use, multi-purpose anti-freeze/anti-boil and corrosion inhibitor that is suitable for a wide variety of vehicles on Australian and New Zealand roads. This product is safe to use in a variety of vehicles as a top-up to existing anti-freeze/anti-boil red coolant or as a full service coolant with a 4 years or 200,000km service life.

Features:

• Anti-freeze/anti-boil protection for 4 years or 200,000km
• Contains long life inhibitor technology for corrosion protection of all cooling system metals
• Ready to use and suitable for a wide range of vehicles in Australia and New Zealand
• Protects aluminium, steel, cast iron, solder, copper and brass
• Provides maximum protection against cavitation damage and cylinder liner pitting
• Safe for all hoses, gaskets and seals
• Safe to mix with existing green coolant

Directions as Complete Fill:

1. Refer to the owner’s manual for cooling system capacity.
2. Ensure the engine is switched off and the heater is on.
3. Drain the old coolant (when cool) by removing the drain plug or bottom radiator hose.
4. Flush the cooling system with clean water to remove all traces of old coolant.
5. Add Green General Purpose Coolant Premix.
6. Secure the radiator cap, start the engine, and bleed air from the system if necessary.
7. Check the coolant level when the system is cool.

As a Top-Up to Existing Coolant:

1. Add as a top-up to existing red coolant.
2. Start the engine and turn the heater on.
3. When the engine is warm, turn it off and allow it to cool.
4. Check the coolant level and top it up if necessary.

Note: 

• The life of Green General Purpose Coolant Premix when used as a top-up defaults to that of the original coolant in the cooling system. If you are unaware of the type or life of the coolant in the system, we recommend a complete coolant change within the next 5000 km or 6 months. For an OEM Replacement Coolant, please use Nulon Long Life Coolant Part No. LL (green), RLL (red), or BLL (blue).

Typical Characteristics:

GPPG

• Density (g/ml @ 15.6ºC): 1.030 - 1.040
• Freezing point: -8ºC
• Boiling point: 123ºC (*using 105kPa radiator cap)
• pH: 8.0 - 9.0
• Reserve alkalinity (ml): 2.8
• Colour: Green
• Glycol content (g/L): 196

Due to continued product research and development, the information contained in this Product Bulletin is subject to change without notification.

Safety:

• Causes serious eye irritation.
• May cause respiratory irritation.
• Use personal protective equipment as required.
• Store locked up.

First Aid:

• If Inhaled: Remove person to fresh air and keep comfortable for breathing.
• If in Eyes: Rinse cautiously with water for several minutes. If eye irritation persists, get medical advice/attention.

Environment:

• Do not pollute drains, soil, or water with used products.
• After use, dispose of the container responsibly. Disposal should comply with local council regulations.

Part number: GPPG-1