Polar Seal is a gamechanger. It’s a protective coating that has been specially formulated for application through a pressure washer and Polar Blaster foam cannon, hose-attached foam gun or hand pressure sprayer.

It imparts a hydrophobic layer onto paintwork that causes water to bead on the surface. This greatly reduces the time it takes to dry the car and helps keep the surface cleaner for longer.
Simply apply to a clean, wet vehicle, rinse off and dry to leave behind a high gloss finish.

Only a small amount of Polar Seal is required. Pour no more than 40ml (four capfuls) into your foam bottle and then add at least 200ml of water. This should be all the finished solution required to cover your vehicle. There is no benefit in using any more than 40ml as over application can compromise the finish.

Features:

• Protective, hydrophobic coating.
• Quick and easy high gloss finish.
• pH neutral.
• Reduces car drying time.
• Can be used on full exterior of vehicle, avoiding windscreen.
• Applied ideally using a pressure washer.

How to Use:

1. We recommend starting with a snow foam like Polar Blast to gently loosen dirt, and follow with Polar Wash to remove any dirt or contamination on your paintwork.
2. Spray Polar Seal onto the clean, wet vehicle, ensuring all exterior surfaces are covered, although avoid direct application to the windscreen.
3. Thoroughly rise and dry your car to reveal a high-gloss finish that is protected with a hydrophobic coating. The car must be dried with a cloth and not allowed to air dry as water spotting may occur.